Plumbing problems rarely wait for a convenient time. The good news is that the most common ones, a dripping tap, a slow sink, a toilet that will not stop running, have simple causes, and some are safe to fix yourself. The important skill is knowing where to stop.
This guide covers the problems we see most often, what to try first, and the signs that you should call a plumber. Whatever you do, start by finding your water shut-off valve, because it is the one thing every household should know.
In this guide
- First: find your shut-off valve
- A leaking or dripping tap
- A blocked sink or slow drain
- Low water pressure
- A toilet that keeps running
- What to do if a pipe bursts
- When to call a plumber
- Stop problems before they start
- Frequently asked questions
First: find your shut-off valve
Every home has a main valve that stops the water supply to the property, and many fixtures have their own small valve under the sink or behind the toilet. If a pipe bursts, a tap will not close or water is coming through a ceiling, closing the valve stops the damage while you work out what to do next.
Find it today, not during an emergency. Check that it turns, and make sure everyone in the house knows where it is. If you use a storage tank and pump, know how to switch the pump off as well.
A leaking or dripping tap
A dripping tap is usually caused by a worn washer, seal or cartridge inside the tap. It looks small, but a constant drip wastes water, stains basins and can hide a bigger fault. Turn off the supply to the tap, replace the worn part and check the drip has stopped. If the tap body is corroded or the leak comes from the base, it is often better to replace the tap.
Call a plumber if you cannot isolate the supply to the tap, the parts do not match or the tap is part of a built-in fitting.
A blocked sink or slow drain
Most kitchen sink blockages are grease, food scraps and soap residue. Bathroom basins and showers usually block with hair and soap. Start gently:
- Remove any visible debris from the plughole.
- Use a plunger. Cover the overflow hole so the pressure goes down the pipe.
- Clean the trap (the U-shaped section under the sink). Put a bucket underneath first, because it holds water.
- Flush with hot water once it flows again.
We suggest avoiding harsh drain chemicals. They are hazardous to handle and can damage some pipes. If more than one fixture is slow, if water backs up in other places or if there is a bad smell from the drain, the blockage may be deeper in the pipework. That is a job for a plumber.
Low water pressure
Start by working out how widespread the problem is. If only one tap is weak, the cause is local: a clogged aerator (the small mesh at the tap spout) or a partly closed valve. Unscrew the aerator, rinse out any grit and scale, and refit it.
If every tap in the house is weak, the cause is further back. It could be your supply, a partly closed main valve, a faulty pump or a leak somewhere in the pipework. Check the main valve is fully open, and if you use a pump and tank, check the pump is working and the tank has water. If the problem remains, ask a plumber to investigate.
A toilet that keeps running
A toilet that keeps filling or hisses after flushing is usually a worn flush valve seal or a fill valve that is not shutting off properly. Lift the cistern lid and watch. If water is trickling into the bowl, the seal is probably worn; if water keeps running into the cistern, the fill valve is the likely culprit. Both are inexpensive parts that a plumber can replace quickly. Left alone, a running toilet wastes a surprising amount of water.
What to do if a pipe bursts
- Close the main shut-off valve straight away.
- Switch off electricity to any wet area if you can do so safely, and keep away from sockets and appliances that are wet.
- Open taps to drain the pipes and reduce the leak.
- Move belongings out of the way and mop up standing water.
- Take photos of the damage, then call a plumber.
When to call a plumber
- You cannot stop a leak, or you cannot find where it is coming from.
- Water is coming through a ceiling or wall.
- Drains back up or several fixtures are slow at once.
- Pressure is low everywhere in the house.
- You have damp patches, staining or a musty smell with no obvious cause.
- The job involves cutting into pipework or replacing a fixture and you are not confident.
You can book a plumber through us: choose the problem, tell us where you are, approve one clear quote and follow the job in your account. For anything urgent, message us through our contact page.
Stop problems before they start
- Do not pour cooking fat or oil down the sink. Wipe pans first.
- Use drain covers in showers and basins to catch hair.
- Run every tap and flush every toilet monthly and check for drips. Our home maintenance checklist includes a quick plumbing check.
- Fix small leaks early. They waste water and can cause damp walls and paint failure over time.
Frequently asked questions
How do I find my main water shut-off valve?
It is usually where the supply pipe enters the property, often outside near the boundary or inside near the meter or the point where the pipe comes into the house. Find it before you need it, and check it turns. If you cannot find it, a plumber can show you.
Why is the water pressure low at only one tap?
A blocked aerator or a partly closed valve is the most common local cause. Unscrew the aerator, rinse out grit and scale, and refit it. If it is still weak, the tap itself may need attention.
Is a small drip worth fixing?
Yes. A constant drip wastes water, stains fixtures and can hide a bigger problem. Worn washers and cartridges are cheap parts and are quick to replace.
When is a plumbing problem an emergency?
Water you cannot stop, water coming through a ceiling or near electrics, or sewage backing up. Close the main valve, switch off electricity in affected areas if safe, and call a plumber straight away.